2.4 mil

90# air egress liner

40 oz/in. to stainless steel

Printer settings will vary between printer manufacturers. Recommended heater settings: Pre-heat 30° C, platen 33° C and post-heat 35° C have been found as a good place to start.

For wrap applications, partner with LexJet Simple Flo Wrap Gloss UV Laminate (2.4 mil). Before finishing, trimming and installing the graphic, allow the image to completely evaporate and dry for a minimum of 24 hours to ensure the solvents are gone from the print. Failure to do so may facilitate solvent penetration, resulting in vinyl degradation. Application surface should always be cleaned, tested and checked for defects before applying the LexJet Simple Flo Wrap Vinyl solution. This product can be installed using the wet application method.

Removable for up to one year under normal exposure conditions from most common substrates. Beyond one year, the adhesive becomes permanent and durable up to seven years. Recommend testing for specific usage.

-40° - 176° F (-40° C to 80° C).

Always roll graphics with the thinnest material facing out. When both materials are the same thickness, always roll them in the same way every time. LexJet recommends rolling the graphic with a minimum 12 inch diameter.

1 year from the LexJet ship date when stored in proper conditions.