3-in adaptable

24 in

100 ft

1 Roll

1x Edge Points

No

Water Resistant

130 gsm

8 mil

Inkjet Printable Media

Banner

Banners, Banner Stands, Featured, POP/ Indoor Signage, Posters, Temporary Outdoor Signage

Matte, Smooth

Aqueous, Latex

Opaque

Banner, Polypropylene

Matte Polypropylene (100% Recyclable Material)

130 gms

Weft 22, Warp 13

8-15

L* = 93.27, a*= -0.56, b*= -1.47

For the best and most consistent results, a profile should be created using an external color calibrator in conjunction with your RIP and color matching software. However, if these tools are not available printers should be set for the highest print quality and media selection should be "heavy coated". Ink coverage up to 250% is recommended.

Grommets should be placed in the hemline along the length of the banner so that the grommet is through two layers. Corner grommets should be placed where the length and width hems cross, so that the grommet is through four layers. A reinforced corner is also recommended to increase durability.

Pressure sensitive vinyl laminates like LexJet's Elite UV Vinyl can be applied to increase the fade and abrasion resistance of the image. Before applying the laminate, allow the image to dry for 24 hours.

Due to the absorptive nature of the coating, you should avoid touching the coated surface. It's always recommended that cotton gloves be used when handling inkjet coated materials. Rolls of LexJet film are supplied with the coated side facing out.

70° F (21° C), 50% R.H. (a controlled environment is recommended); store in original packaging.