2 in

24 in

40 ft

1 Roll

1x Edge Points

No

Water Resistant, Tear Resistant

Inkjet Printable Media

16 mil

450 gsm

Banners, Temporary Outdoor Signage

Matte

Aqueous

Vinyl: Banner, Banner

Tear-resistant polyester fabric embedded between two white vinyl layers

450g

>95

L* = 93.27, a*= -0.56, b*= -1.47

Material is packaged with printable side facing up. Printable surface can be identified by a slight tackiness.

Pressure-sensitive vinyl laminates, like LexJet Elite UV Vinyl, can be applied to increase the fade and abrasion resistance of the image. Before applying the laminate, allow the image to dry for 24 hours.

To obtain a high degree of water resistance, use only pigmented ink. Allow the print to dry for 24 hours before exposing to moisture. Lamination is not required. Ink saturation over 250% can affect the waterfast properties and show ink bleed. Dye-based inks will yield good color gamut, but bleeding may occur when the image gets wet. Over laminating dye-based ink will not eliminate image bleed, unless the material is completely sealed to a non-porous surface. To avoid perforating the laminate, use banner tape instead of sewing (see below). Dirt and stains cannot be cleaned from the imaged surface and the surface can be damaged from excessive folding or creasing.

Grommets should be placed in the hemline along the length of the banner so that the grommet is through two layers. Corner grommets should be placed where the length and width hems cross, so that the grommet is through four layers. A reinforced corner is also recommended to increase durability.

Due to the absorptive nature of the coating, you should avoid touching the coated surface. It's always recommended that cotton gloves be used when handling inkjet coated materials. Rolls of LexJet film are supplied with the coated side facing out.

40° F

1 year from the LexJet ship date when stored in proper conditions.