3 mil

3 in

54 in

150 ft

1 Roll

1x Edge Points

Laminates & Coatings

Pressure Sensitive

Backlit, Museum, Banner, Outdoor Signage, Banner Stand, POP / Indoor Signage, Posters, Trade Show

Satin

Pressure Sensitive

Vinyl (PVC)

3 mil calendered PVC film

40# polycoated Kraft paper

PSTC 7, 1 sq. in., 4 lb. load : 25+ hours no failure

Printer manufacturers recommend that you allow your print to dry for a minimum of 24 hours before lamination. In areas with high humidity dry times can be longer.

NO HEAT IS REQUIRED. Apply 40-80 psi and use 2-5 feet per minute for dwell time depending on the application.

After applying the laminate, allow curing for a minimum of 2 hours before cutting or trimming. Maximum bond strength is reached in 24 hours.

70° F (21° C), 50% R.H. (a controlled environment is recommended); store vertically in original packaging.

It is not recommended that you pre-coat any paper-faced products, such as Gator Board or Foam Core, with an adhesive that has a plastic carrier. The absorptive nature of paper products can cause the board to contract and expand with temperature and humidity fluctuations causing the release liner to tunnel. The slip aid, which is often found on PVC materials, should be removed with a suitable detergent. All substrates should be tested for your specific application prior to final job production.