38 in

10 mil

3 in

75 ft

1 Roll

1x Edge Points

Laminates & Coatings

Pressure Sensitive

Yes

Backlit, Museum, Interior Floor, Outdoor Signage, Backlit Graphic Diffuser, Trade Show, POP / Indoor Signage

Textured, Luster

Pressure Sensitive

Polycarbonate

10 mil Bayer Makrofol Polycarbonate PCVE film with velvet/textured finish

1.5 mil clear oriented polyester

(ASTM D-882): 7000 psi

(ASTM D-882): 170%

Printer manufacturers recommend that you allow your print to dry for a minimum of 24 hours before lamination. In areas with high humidity dry times can be longer.

Apply 80-100 psi and use 2-3 feet per minute for dwell time. Between 90° to 120° F heat is recommended, but heat is not required. The top and bottom web tension should be minimal.

After applying the laminate, allow curing for a minimum of 2 hours before cutting or trimming. Maximum bond strength is reached in 24 hours.

50° F (10° C)

1 year from the LexJet ship date when stored in proper conditions.

It is not recommended that you pre-coat any paper-faced products, such as Gator Board or Foam Core, with an adhesive that has a plastic carrier. The absorptive nature of paper products can cause the board to contract and expand with temperature and humidity fluctuations causing the release liner to tunnel. The slip aid, which is often found on PVC materials, should be removed with a suitable detergent. All substrates should be tested for your specific application prior to final job production.